The PushCorp DM100  Disk Manager is an excellent solution for automated abrasive disk changing operations.  The DM100 combines a disk change time of less than 8 seconds with a capacity of 30 disks for efficient unattended operation.  In addition, the DM100 can be fully reloaded in less than 2 minutes without interrupting operation.
The DM100 is unsurpassed in ease of use and ease of integration into your robotic work cell.  A universal Disk Collet DC100 allows you to use the motor of your choice.  The Disk Manager is controlled completely through seven industry standard 24V digital control lines.  Mount the DM100 to the floor, connect air and electrical power, and installation is completed in a matter of minutes!
The DM100 Disk Manager, is, quite simply, the fastest, most reliable, easy-to-use piece of equipment of its kind in the world.

FEATURES

	Storage capacity of 30 disks
	Disk change time of less than 8 seconds
	Handles any mix of 4 - 7 in. diameter abrasive disks
	Handles any mix of abrasive disk media
	Stored disks load from outside robot workspace
	Disks can be loaded during operation
	Single taught point for disk drop-off / pick-up
	Configurable for robot approach from right or left
	Detects and warns of empty condition
	Universal Disk Collet mounts to any motor
	Universal Disk Collet requires NO electrical or pneumatics

Supply:  110 - 120 VAC, 60 Hz, 100 W
Interface: Standard 24 VDC Digital
Control lines:
     Inputs: Start, Stop, Change Disk
     Outputs: Ready, Cycle Complete,
                   In Position, Empty, Error

Footprint: 14" x 63"
               (339mm x 1577mm)
Height: 95 in. (2407mm)
Pneumatic Supply: Dry, 5m filtered,
Non-lubricated, 100 psi (6.9 Bar) min.
Collet motor mount: Customer specified